Auto Detect Error

Auto Detect Error

  1. This error occurs when the S80 is searching for a connection to an External Pinpad i.e SP20 V4. 
  2. If the S80 is not connected to a Pinpad, go into the terminal and change the PINPAD Type to Internal
    1. This change can also be made on the file in the MISC Tab in Subsection Peripherals.
  3. If the S80 is connected to a PinPad, set the PinPad Type to External, and the Contactless Reader to Auto.

    • Related Articles

    • Auto Detect Error - PIN pad

      Auto-Detect Errors occur from the PIN Pad such as an SP20v4 or SP30s mono cable connecting to a terminal like an S80/A80. To resolve the issue, make sure that the PIN Pad Type is set to External and the Contactless Module/External Card Reader is on ...
    • Comm Error/Communication Error

      Comm Error This error occurs when trying to connect a Semi-Integrated terminal (SP30s, S300 etc.) to a POS or after processing a transaction. The POS can be the merchant's computer system or a PAX S80. The error will appear on the PAX terminal and it ...
    • Send Error

      Host response. This error appears when batching. Contact the host to determine what is wrong with batch or if there are any bad transactions in the batch. The host will be able to inform you why they can not accept the batch information. 
    • Handshake Error

      Handshake Error: This occurs during a Firmware Update The terminal is not connecting to PAXSTORE or the firmware server. If this happens during a Firmware update make sure you are using the correct Port #, IP Address, and TID. Also, verify the port ...
    • Invalid Track Error

      The error message listed above means that the information on the Magnetic Stripe cannot be read by the terminal. The Mag Reader could be dirty, or the card is dirty. You can clean the Mag reader by taking a paper towel and running it though the mag ...